山东装载机http://m.132p.cn/圆弧齿轮综合曲率半径比渐开线齿轮传动大很多，其接触强度比渐开线齿轮传动约高0.5～1.5倍；两轮齿沿啮合线方向的滚动速度很大，齿面间易于形成油膜，传动效率较高，一般可达0.99～0.995。
Shandong comprehensive than the radius of curvature of the loader arc gear involute gear drive many large, high-contact transmission strength of about 0.5 to 1.5 times higher than involute gear; two teeth meshing line along the direction of the scrolling speed is large, between the tooth surface easy to form a film, high transmission efficiency, usually ranging from 0.99 to 0.995.

山东装载机圆弧齿轮是装载机配件中的一部分，工作是沿齿高方向磨损均匀，且容易跑合，无根切现象，故最小齿数可以少。齿轮对中心距、切齿深度和螺旋角的误差敏感性很大，这三项误差对承载能力影响较大，故圆弧齿轮对制造和安装精度要求较高。
Shandong loader loader accessories arc gear is part of the work is high along the direction of the tooth wear uniform, and easy to run together, without undercutting phenomenon, it is the smallest number of teeth can be less. Gear to

center distance, Cutting error sensitivity of great depth and helix angle, the larger of the three errors on the carrying capacity, so arc gear on the manufacture and installation of high precision.

山东装载机http://m.132p.cn/圆弧齿轮的操作允许有误差的存在，但误差不能太大，要求安装精度，工作对精度的要求也比较严格，尽量将误差控制在最小的范围内。
Shandong loader operation arc gear allows the existence of error, but the error is not too large, require the installation of precision, accuracy requirements are more stringent, as the error control in the smallest range.