一般情况下，装载机http://m.132p.cn/对于前轮，胎肩的磨损要大于胎心，这是因为前轮经常要转动以改变汽车的行驶方向；而对于后轮，胎心的磨损则要大于胎肩。另外，前轮驱动的车辆，其前轮轮胎的磨损几乎是后轮轮胎的2倍；而后轮驱动的车辆，其后轮轮胎的磨损也比前轮轮胎的磨损大很多。为了使装载机每条轮胎都能均衡地磨损，延长轮胎的使用寿命，当汽车行驶5000～10 000km时，要进行一次轮胎换位。
In general, for the front wheel loaders, the shoulder wear is greater than the fetal heart rate, which is often due to the front wheel to be rotated to change the traveling direction of the vehicle; and to the rear wheels, the fetal heart rate will have to be greater than the shoulder wear. In addition, the front-wheel drive vehicle, its front tire wear is almost twice the rear tire; and rear-wheel drive vehicle, its rear tire wear is also much larger than the front tire wear. In order to make the loader can be balanced each tire wear and extend tire life, when cars with 5000 ~ 10 000km, we should conduct a tire rotation.

装载机的轮胎、轮毂如果处理不当，会造成轮胎会爆炸、轮毂会破碎等。因此处理好装载机轮胎的工作非常重要。 使用指定的轮胎，并充气到规定压力。充气时，应不断检查轮胎气压，防止充气气压过高充气管上应有能固定到气门上的管卡，并禁止任何人进入工作区域。轮毂如果固定不好，轮胎充气时轮毂可能会产生爆裂。为确保安全，在轮胎充气工作区周围应设置一个防护栏。
Loader tires, wheels if handled improperly, can cause the tires to explode, wheels, etc. will be broken. Therefore handle loader tires is very important. Using the specified tire, and inflated to a predetermined pressure. Inflated,should continue to check the tire pressure, to prevent excessive inflation pressure due inflatable tube can be fixed to the tube valve on the card, and prohibits any person entering the work area. If the fixed bad wheels, wheels may have inflated the tire burst. To ensure safety, the tire around the work area should be set to a fence.

装载机轮胎压力下降速度异?；蚵朱弊爸靡斐Ｏ窒蠖际锹痔ヂ朱庇形侍獾恼髡?。这种情况下，要请轮胎维修站的人员进行维修。装载机高速行驶或繁重作业后，要调整轮胎的压力，禁止对安装在轮胎上的轮毂进行加热或焊接，禁止将轮胎靠近火源。
Loader tire pressure drop velocity anomalies or hub device anomalies tire wheels are signs of a problem. In this case, tire repair station to ask the staff for maintenance. After high speed or heavy loader work, to adjust the tire pressure is prohibited wheels mounted on a tire heating or welding, prohibit the tire near the fire.

装载机http://m.132p.cn/轮胎轮毂的拆装、保养及维修需要专用设备和技术，所以为以防万一，建议最好是请轮胎维修点的人员进行操作。
Wheel loader tire disassembly, maintenance and repair needs special equipment and technology, so as a precaution, we recommend that the best is to ask the staff to operate a tire repair point.